Cisco Headend System Release 2.7 安装指南
Configure the Direct ASI Cards
4017650 Rev C
77
8 Does /dev/Hmux0 appear in the Inband Device Name field?
If yes, go to step 9.
If no, click in the Inband Device Name field, type /dev/Hmux0, then go to
step 9.
step 9.
9 Does the transport stream (TS) ID shown in the QAM BFS Input TSID field
match the Home SCS/MQAM TSID that you defined when you configured the
MPEG sources?
MPEG sources?
If yes, go to step 10.
If no, click in the Transport Stream ID field, type the correct TS ID, then go to
step 10.
step 10.
10 Verify that the RF Output TSID for BFS Port entry is correct.
Important: The RF Output TSID for BFS Port field specifies the RF output port
number corresponding to the MQAM/SCS device output. The value for this field
will be the value in the output TSID found on the SCS page. For additional
details, see Setting Up SCS Ports Modeling Parameters (on page 58).
number corresponding to the MQAM/SCS device output. The value for this field
will be the value in the output TSID found on the SCS page. For additional
details, see Setting Up SCS Ports Modeling Parameters (on page 58).
11 Verify that the PSI Interval setting is correct.
Note: The PSI interval is the interval at which the PAT and the PMT are
transmitted by the ASI card. The default value is 80 msec.
transmitted by the ASI card. The default value is 80 msec.
12 Is Port 0 (zero) selected?
If yes, go to step 12.
If no, select 0 (zero), then go to step 12.
13 Verify the setting in the Bandwidth field.
Note: The recommended setting is 38.80 Mbps.
14 Click Save to save your settings. Your settings are saved and the BFS
Administration window opens.