Cisco Headend Digital Broadband Delivery System 安装指南
Chapter 3 Installing the DTACS Software for the First Time
14
78-4036705-01 Rev D
Configure the Service Processor Network
Management Port
Complete the following steps to configure the network management port.
1 Type set /SP/network pendingipdiscovery=static and press Enter to disable
1 Type set /SP/network pendingipdiscovery=static and press Enter to disable
DHCP for the network management port.
2 Type set /SP/network pendingipaddress=<xxx.xxx.xxx.xxx> and press Enter to
set the IP address of the network management port.
Note: Replace <xxx.xxx.xxx.xxx> with the IP address for the network
management port.
Note: Replace <xxx.xxx.xxx.xxx> with the IP address for the network
management port.
3 Type set /SP/network/pendingipgateway=<xxx.xxx.xxx.xxx> and press Enter to
set the Default Gateway for the network management port.
Note: Replace <xxx.xxx.xxx.xxx> with the gateway IP address for the network
management port.
Note: Replace <xxx.xxx.xxx.xxx> with the gateway IP address for the network
management port.
4 Type set /SP/network pendingipnetmask=<xxx.xxx.xxx.xxx> and press Enter to
set the network mask for the network management port.
Note: Replace <xxx.xxx.xxx.xxx> with the network mask for the network
management port.
Note: Replace <xxx.xxx.xxx.xxx> with the network mask for the network
management port.
5 Type set /SP/services/ssh state=enabled and press Enter to configure the
network management port to use SSH.
6 Type set /SP/network state=enabled and press Enter to enable the network
management port.
7 Type show /SP/network and press Enter to display the current network
management port settings.
8 If any of the settings are incorrect, retype the necessary command to set the
parameter to the proper value and then repeat step 7.
9 Type set /SP/network commitpending=true and press Enter to complete and
implement the new network management port settings.