Cisco Headend System Release 2.5 安装指南
Chapter 1 Install the InView Client 3.6 Software
6
4019969 Rev B
Install InView Software on the DNCS
Overview
After installing the application files in a subdirectory and determining how
subscribers will access InView services, you are ready to install the InView Client 3.6
software on the DNCS. This section provides installation instructions.
Contents of the InView Package
InView, packaged on the Fusion 1.3 CD (part number 4014183), contains the
following directories:
InView
HTMLEngine
eVOD
Installing the Software on the DNCS
Note: System components do not have to be shut down to install this software.
1 Open an xterm window on the DNCS, if necessary.
2 Type su root and press Enter to log on as root user. The password prompt
1 Open an xterm window on the DNCS, if necessary.
2 Type su root and press Enter to log on as root user. The password prompt
appears.
3 Type the root password and press Enter.
4 Insert the Fusion 1.3 CD (part number 4014183) that contains the InView
4 Insert the Fusion 1.3 CD (part number 4014183) that contains the InView
application into the CD-ROM drive of the DNCS. The system automatically
mounts the CD to /cdrom/cdrom0 within 30 seconds.
5 Type df and press Enter to confirm that the system mounted the CD
successfully. The last line of the df command output lists the number of free disk
blocks on the CD. This is your indication that the system successfully mounted
the CD.
6 Type swmtool -d /cdrom/[directory where CD was mounted] and press Enter.
7 From the Admintool: Add Software window, click Cancel.
8 From the Admintool: Software window, click Properties and select Package
7 From the Admintool: Add Software window, click Cancel.
8 From the Admintool: Software window, click Properties and select Package
Administration.