Cisco Headend System Release 2.7 安装指南
Add and Configure the RNCS
4022447 Rev B
45
Device Type—Select the device type associated with this MPEG source. If
the source will provide VOD data, select the Service Group Object option.
the source will provide VOD data, select the Service Group Object option.
IP Address—Enter the IP address for this MPEG source.
Physical Address—Enter the MAC address for the MPEG source.
6 Click Apply. The system saves the basic parameters for this MPEG source in the
DNCS database. The previously disabled Connectivity tab becomes available.
7 Click Apply. The system saves the MPEG source information in the DNCS
database and updates the Connectivity illustration to include the new port
information.
information.
8 Click Save. The system saves the MPEG source information in the DNCS
database and closes the Set Up MPEG Source window. The MPEG Source List
window updates to include the new MPEG source.
window updates to include the new MPEG source.
9 Repeat this procedure from step 4 for additional MPEG sources you need to
create.
10 You will connect the MPEG source to an RNCS QAM after you create the other
video MPEG sources and add the QAM.
Adding a BFS QAM
Complete these steps to add a BFS QAM modulator for the RNCS.
1 On the DNCS Administrative Console, click the DNCS tab.
2 Click the Network Network Element Provisioning tab.
3 Click QAM. The QAM List window opens.
4 Click File > New > QAM. The Set Up QAM window opens with the Basic
1 On the DNCS Administrative Console, click the DNCS tab.
2 Click the Network Network Element Provisioning tab.
3 Click QAM. The QAM List window opens.
4 Click File > New > QAM. The Set Up QAM window opens with the Basic
Parameters tab in the forefront.
5 Complete the following:
Headend Name—Select the headend in which this BFS QAM modulator
resides.
resides.
QAM Name—Enter the name you will use to identify this BFS QAM
modulator. You can use up to 15 alphanumeric characters. Be sure to use a
name that is consistent with the naming scheme used on your network map.
modulator. You can use up to 15 alphanumeric characters. Be sure to use a
name that is consistent with the naming scheme used on your network map.
IP Address—Enter the IP address for this QAM modulator.
Modulation Type—Select the type of modulation standard this modulator
uses.
uses.
MAC Address—
Enter the MAC address for this QAM modulator.
Subnet Mask—Enter the subnet mask where this QAM modulator resides.
Default Gateway—If your system uses a default gateway, enter the IP
address of the default gateway. Using a default gateway speeds up the
reconnection process that occurs after a BFS QAM modulator is rebooted.
address of the default gateway. Using a default gateway speeds up the
reconnection process that occurs after a BFS QAM modulator is rebooted.