Cisco Headend System Release 2.7 安装指南
Chapter 1 Preparing to Install the Software
12
4026031 Rev B
Stopping RNCS Processes at All Sites
1 Open an xterm window on the DNCS as the dncs user.
2 To stop RNCS processes at all sites in your system, type siteCmd -a lionnStop
1 Open an xterm window on the DNCS as the dncs user.
2 To stop RNCS processes at all sites in your system, type siteCmd -a lionnStop
and press Enter.
3 When the system prompts you to verify that you want to "stop the LIONN" (all
RNCS processes at all sites), type Y (yes) and press Enter to confirm that you
want to stop the processes on all sites in your system. The system informs you
that it is stopping LIONN Applications (processes on all sites in your system),
and displays the command prompt for the DNCS user.
want to stop the processes on all sites in your system. The system informs you
that it is stopping LIONN Applications (processes on all sites in your system),
and displays the command prompt for the DNCS user.
4 Follow the on-screen instructions to exit the utility. Then go to Stopping
Spectrum NMS (on page 14).
Stopping RNCS Processes at One Site
1 Open an xterm window on the DNCS as the dncs user.
2 To stop RNCS processes at each site in your system, one at a time, type
1 Open an xterm window on the DNCS as the dncs user.
2 To stop RNCS processes at each site in your system, one at a time, type
siteControl (host name of the RNCS) and press Enter. For example if "houston"
is the name of the RNCS host, you would type siteControl houston. A menu
opens, similar to the following example, that allows you to stop the RNCS
processes at this site.
is the name of the RNCS host, you would type siteControl houston. A menu
opens, similar to the following example, that allows you to stop the RNCS
processes at this site.