Cisco Headend System Release 2.5 用户指南
749640 Rev C
Examine the Database for Expiring EMMs With the emm_check Utility
5-3
Run the emm_check Utility
Introduction
System operators can run the emm_check utility in either of the following modes:
•
•
Run the emm_check utility in default mode (no options) to check the DNCS
database and to correct conditions that may prevent the camAuditor process from
functioning correctly.
•
Run the emm_check utility with the –v option to display the version number of the
emm_check.sh utility currently installed on the DNCS.
Note: When the emm_check utility is run with the –v option, no checks of the
Note: When the emm_check utility is run with the –v option, no checks of the
database occur.
Running the emm_check Utility
Follow these instructions to run the emm_check utility.
1.
If necessary, open an xterm window on the DNCS.
2.
Choose one of the following options:
•
•
To check the DNCS database and to correct conditions that may prevent the
camAuditor process from functioning correctly, go to step 3.
•
To display the version number of the emm_check utility currently installed
on the DNCS, go to step 4.
3.
Type emm_check.sh and then press Enter to check the DNCS database and to
correct conditions that may prevent the camAuditor process from functioning
correctly.
Result: The emm_check utility runs to assess the soundness of the
Result: The emm_check utility runs to assess the soundness of the
camAuditor process on the DNCS and displays the following message:
This script performs three database checks on the DNCS to detect
This script performs three database checks on the DNCS to detect
potentially serious conditions. Each check takes a few minutes.
Please be patient …
Note: Refer to Analyze the Output of the emm_check Utility, next in this
Note: Refer to Analyze the Output of the emm_check Utility, next in this
chapter, for guidance in analyzing the output from the emm_check utility.
Continued on next page