Cisco Headend System Release 2.5 用户指南
749640 Rev D
Change DHCT Status to Out-of-Service With the 2way2oos Utility
9-5
Stop and Restart the HCT Manager Processes
Introduction
You need to stop and restart the HCT Manager processes on the DNCS in order to
reclaim the IP addresses associated with the DHCTs in your text file. The
instructions in this section guide you through the steps of stopping and restarting
the HCT Manager processes.
Note: Stopping and then restarting a process is often referred to as “bouncing” the
Note: Stopping and then restarting a process is often referred to as “bouncing” the
process.
Stopping the HCT Manager Processes
Follow these instructions to stop the HCT Manager processes on the DNCS.
1.
If necessary, open an xterm window on the DNCS.
2.
Type dncsControl and then press Enter.
Result: The Dncs Control window opens.
Result: The Dncs Control window opens.
Continued on next page