Cisco GainMaker High Gain Balanced Triple Amp 1GHz with 40 52 MHz Split 安装指南
Chapter 2 Installation and Configuration
28
4011881 Rev B
T9750
Coax Out
Coax Out
Power In
Strand Clamps
Strand
Coax Out
5
5
3
3
2
2
1
1
4
4
6
6
Note:
Power In may be switched or combined with the Coax Out if you reverse the
amplifier module and feed the signal from right to left..
amplifier module and feed the signal from right to left..
If supplying power to the node through the main input port, a power inserter
must be installed to terminate the RF signal.
must be installed to terminate the RF signal.
5 Tighten the strand clamp bolts (using a ½-inch torque wrench) from 5 ft-lb to 8
ft-lb (6.8 Nm to 10.8 Nm). Make sure there is good mechanical contact between
the strand and the housing.
Note: A slight tilt of the face of the housing is normal. Cable tension will cause
the housing to hang more closely to vertical.
the strand and the housing.
Note: A slight tilt of the face of the housing is normal. Cable tension will cause
the housing to hang more closely to vertical.
6 Connect the coaxial cable to the pin connector according to connector
manufacturer specifications.
7 Proceed to Installing Accessories (on page 30).
To Install the Node in a Pedestal
Complete the following steps to install the node in a pedestal.
1 Remove the cover of the pedestal.
2 Remove the self-tapping bolts from the strand clamps and set the bolts and
1 Remove the cover of the pedestal.
2 Remove the self-tapping bolts from the strand clamps and set the bolts and
strand clamps aside.