Cisco Model 6385 BTSC Stereo Encoder (NTSC) 安装指南

 

450 

78-4021139-01 Rev D 

Enter the IP address of the nameserver at the prompt. 

 

Do you want to set a hostname? (yes/no)

 

Answer yes if you would like the machine to have a unique name on your 

network. If you answer yes, you will be prompted with the next two 

questions. 
– 

Enter the hostname from the original server:

 

– 

Enter the domainname:

 

Enter the requested information at the prompts. 

 

Do you want this USRM server to be provisioned via SNMP? (yes/no)

 

Answer yes if you have a DNCS server or other SNMP provisioner on your 

network that you would like the USRM to acquire its provisioning from. If 

you answer yes, you will be prompted with the following two questions. 
– 

Enter the SNMP Provisioner IP address:

 

– 

Enter the SNMP Provisioner Host Name [dncsatm]:

 

 

Type the IP address and name of your SNMP Provisioner. To form the name, 

use only valid characters A-Z, a-z, and 0-9. To use the default name 

(dncsatm), just press Enter. 
The system displays a message similar to the following: 

host=dncsatm

 

Writing DNCS config file... Done.

 

Adding dncsatm entry to the /etc/hosts file... Done.

 

Note: In the example above, dncsatm is replaced by your specific host name, 

if you chose one. 

 

Do you want to set up interfaces on the USRM server? (yes/no)

 

Answer yes if you want to set which protocols go out which ports. If you 

answer yes, you will be prompted with the next question. 

Select a custom configuration:

 

(1)  All USRM interfaces on one physical interface (eth0)

 

(2)  Management on separate interface. (http on eth1, all others on eth0)

 

(3)  MiniCarousel on separate interface. (MCP on eth1, all others on eth0)

 

(4)  Defaults.  Do not write a custom config.

 

Select option 1, 2, or 3 if that best matches your setup, or enter 4 to use the 

USRM default settings. The system writes the USRM interfaces config file. 

4  Finally, the system prompts you with the following choices. 

Setup Complete. Would you like to:

 

(1) Exit

 

(2) Restart Networking

 

(3) Reboot

 

 Make a selection:

 

Important: Enter 3 to save the new settings and clean reboot the USRM to put 

them into effect. 

Initial server setup is now complete.