Cisco DNCS System Release 2.7 3.7 4.2 用户指南
Chapter 3 Posting Logos with Enhanced SARA
18
738163 Rev C
Introduction to Enhanced SARA
When sites that are running Enhanced SARA display standard ("legacy") logo files,
the logo appears much smaller than expected. You can address this problem by
creating two additional logo files:
servicelogo.res. This file can be an existing service logo file already being used
with low resolution SARA.
servicelogo.hi.res. This file contains the same logos as in the servicelogo.res file,
but these are high resolution logos. Each logo in the servicelogo.res file should
have a matching logo in the servicelogo.hi.res file and the logo ID must match.
The following table explains some of the differences between standard SARA and
Enhanced SARA:
Title
Standard SARA
Enhanced SARA
Resolution of
Logos
Supports low-resolution
Service and MSO logos
Supports the following:
low-resolution ("legacy") logos
high-resolution logos
Logo files
Supports a single Service
Logo file (such as
servicelogo.res)
Supports two new files:
servicelogo.hi.res, which contains
high--resolution logos defined by the
service provider, with IDs from 256
and above.
servicelogo.default.hi.res, which
contains high-resolution logos for
service logos with IDs from 1 - 255.
Important: If you use these files, then you
should check the contents of the files to
make sure that the logo IDs match
between these files and their low-
resolution counterparts.
Resource ID
Numbering is
contiguous.
Size of MSO logo Maximum size is 54 x 37
(low-resolution only)
Maximum size of 54 x 37 for a
low-resolution logo or 100 x 40 for a
high-resolution logo
Size of channel
logos
Maximum size is 25 x 25
(low-resolution only)
Maximum size of 25 x 25 for a
low-resolution logo or 100 x 40 for a
high-resolution logo