Cisco DNCS System Release 2.7 3.7 4.2 安装指南
78-4011510-01 Rev C
Install and Configure the Digital System Time Kit to Use the
2-9
Global Positioning System
Install the Digital System Time Kit,
Continued
15. Does your system still display the “No such file or directory” message?
•
If yes, contact Cisco Services for further assistance. See Chapter 7,
Customer Information, to locate an assistance center in your area.
•
If no, go to step 16.
16. Type /etc/rc2.d/S99xntpd stop and press Enter.
Result: The system stops the S99xntpd process and displays the command
prompt.
17. Type /etc/rc2.d/S99xntpd start and press Enter.
Result: The system restarts the S99xntpd process and displays the command
prompt.
18. Type exit and press Enter to exit as root user.
19. To verify the time and date, type date and press Enter.
20. Is the DNCS clock set to within 16 minutes of the correct time?
19. To verify the time and date, type date and press Enter.
20. Is the DNCS clock set to within 16 minutes of the correct time?
•
If yes, perform the procedures found in Verifying DNCS Connectivity in
the DBDS System Time Synchronization Maintenance section of
Chapter 4. Then, go to step 21 of this procedure.
•
If no, go to Chapter 4, DBDS System Time Maintenance, and perform the
procedures in that chapter. Then, repeat this procedure from step 10.
21. Wait approximately 15 minutes; then, verify that the DNCS is using the GPS
as the clock reference.
Important: In order to verify that the DNCS is using the GPS as the clock
Important: In order to verify that the DNCS is using the GPS as the clock
reference, go to Verify the Installation Using the Doctor Report, next in this
chapter.
22. Stop and then restart the siManager and qamManager processes on the
DNCS. Then, return to step 21 of this procedure.
Note: See Chapter 5, Reset System Processes, for detailed procedures on
Note: See Chapter 5, Reset System Processes, for detailed procedures on
stopping and restarting the siManager and qamManager processes on the
DNCS.