Cisco DNCS System Release 2.7 3.7 4.2 安装指南

下载
页码 51
 
78-4011510-01 Rev C 
DBDS System Time Maintenance 
4-7 
DBDS System Time Synchronization Maintenance,
 Continued 
Verifying Application Server Synchronization 
Follow these steps to run the ntpq script on the Application Server to verify that the 
Application Server is synchronized with the DNCS. 
1. 
From an xterm window on the Application Server, type /usr/local/xntpd/ntpq 
and press Enter
2. 
Does the ntpq> prompt appear on your screen? 
• 
If yes, go to step 3. 
• 
If no, contact Cisco Services for assistance.  
3. 
At the ntpq> prompt, type peers and then press Enter
Result:  A window similar to the following example appears on the screen. 
 ntpq> peers
 
     remote   refid         st t when poll reach   delay   offset  jitter
 
=========================================================================
 
 *dncsatm   192.168.41.253  3 u  653  1024  377    0.611    0.860   0.586
 
 ntpq>
 
Notes:   
• 
The asterisk (*) in front of dncsatm indicates that the Application Server is 
synchronized to the DNCS. 
• 
If the DNCS is using an NTP server as a time source (as shown in the 
above example), the IP address, URL, or server name of that NTP server 
will be displayed in the refid column. 
• 
If the Application Server is synchronized to a DNCS that is synchronized 
to the GPS source, .GPS will be displayed in the refid column. 
4. 
Is there an asterisk (*) in front of dncsatm on your screen? 
• 
If yes, your Application Server is synchronized to the DNCS. Go to step 5. 
• 
If no, go to Verifying the Application Server xntpd Operation in the 
Synchronize System Component Time Settings section, next in this 
chapter. Then, repeat this procedure. 
5. 
To exit ntpq, type q and then press Enter
6. 
Type exit and press Enter to close the xterm window.  
7. 
Go to DBDS Time Zone/Day Light Savings Time Operation, later in this 
chapter.