Cisco DNCS System Release 2.7 3.7 4.2 安装指南
5-2
Reset System Processes
78-4011510-01 Rev C
Reset siManager
Introduction
This section provides a procedure for resetting the siManager process on the DNCS.
Note: The DNCS automatically updates the time on each device when the
Note: The DNCS automatically updates the time on each device when the
siManager and qamManager processes start, and then the DNCS updates the time
every 12 hours after that.
Important: Perform the procedures in this section immediately after you adjust the
Important: Perform the procedures in this section immediately after you adjust the
time synchronization.
Resetting the siManager Process
This section provides the procedures for resetting the siManager process on the
DNCS.
Note: Resetting the siManager process involves stopping and then restarting the
Note: Resetting the siManager process involves stopping and then restarting the
process. This is also known as “bouncing” the process.
Stopping the siManager Process
Follow these steps to stop the siManager process on the DNCS.
Stopping the siManager Process
Follow these steps to stop the siManager process on the DNCS.
1.
From the DNCS Administrative Console Status window, click Control from
the DNCS section. The DNCS Control window opens.
2.
Select siManager, click Process, and then select Stop Process. A confirmation
window opens.
3.
Click Yes to stop the siManager process. After a few moments, a red icon
appears next to the siManager that indicates the process has stopped running.
Note: Several other processes may also turn yellow while siManager is
Note: Several other processes may also turn yellow while siManager is
stopped. This does not indicate a problem.