Cisco Cisco StadiumVision Director 發佈版本通知

Try to avoid at least 1 of the conditions and the issue will not occur. For example:

For the non-widget region, use a non-video region instead.
or

Move the components further away from the edge of the canvas.

DMP 4310: State change before runtime loads DMP won’t go to correct state.

If the state changes in SVD before the 4310 runtime finishes loading, it will continue to play 

the default multicast video stream and won’t go into the correct state. The following steps recreate the 
conditions when this defect occurs:

Create a script with a blank first state.

Create other states with actions.

Run the script.

When the 4310 runtime is restarting, go to a state with action.

Notice when the 4310 finishes loading the runtime it will stay streaming the default multicast stream and 
not go to the active state selected in SVD. This does not occur 100% of the time. There seems to be a 
window during the runtime start up that when the state changes causes this issue to occur.

This issue also exists in Cisco StadiumVision Director Release 3.2.

Wait until the 4310 runtime has completely started before changing states. If there is a timer 

on the first blank state (best practice) in the script ensure the wait time is long enough. The duration of 
the empty state should be at least two minutes (120 seconds) depending on how many media players are 
in the system and the amount of time it takes to stage content.

The following steps recreate the conditions when this defect occurs:

Add a new suite under the Suits tab. Enter a name under the Intro sub-tab and do not click Save.

Go to the Phone & Remote subtab, assign a device (IP Phone) and click the save button.

Refresh the Luxury Suite List on the left-hand side and click on the suite you created.

Click on the Phone & Remote sub-tab and look for the device (IP Phone) assigned before.

The IP Phone should already be assigned and the checkbox should be selected. Services should be 
available in the newly assigned IP Phone.

The IP phone is not assigned and the checkbox is not selected. In the database a row is created in 
sne_suitemap table with the value 0 for column luxurySuiteId. The IP Phone service is not accessible 
and error message is displayed on IP Phone.