Cisco Cisco 870 MHz GainMaker Amplifiers 安装指南
748052 Rev C
GainMaker Amplifier Reverse Switch Removal Instruction Sheet
3
System Amplifier Reverse Switch Removal
Introduction
The steps required to remove a reverse switch from a system amplifier vary,
depending on whether or not the system amplifier is located in the field.
The following is a list of all possible steps:
•
The following is a list of all possible steps:
•
Disconnecting power from the system amplifier
•
Removing the amplifier module from the housing
•
Removing the reverse switch
•
Repositioning the amplifier module in the housing
•
Reconnecting power to the system amplifier
•
Closing the system amplifier housing
•
Re-boxing the system amplifier
Required Tools and Equipment
Before you start, make sure you have the following tools and equipment:
•
•
Torque wrench with a 1/2-in. socket
•
Flat-head screwdriver
•
Three two-pin jumpers, S-A part number 81630 (provided with these instructions)
•
Two product labels (provided with these instructions)
−
−
3”x 1” amplifier chassis label
−
3”x 2” box label (for amplifiers not located in the field)