Cisco Model D9479 Gigabit QAM Modulator 安装指南
Chapter 1 Introducing GoQAM Software Version 1.1.3
4
78-4024239-01 Rev B
What's Fixed?
Introduction
This section provides a description of the CRs implemented in this software product.
Implemented CRs
CR 55812: GoQAMs No Longer Display Incorrect Package Release Checksums
Previously, the front panel LCD screen would display incorrect package release
Previously, the front panel LCD screen would display incorrect package release
checksums. CR 55812 corrects this issue.
CR 60963: GQAMs No Longer Use NVM Values for Muted RF Frequencies
Previously, GQAMs used the RF frequency values in non-volatile memory (NVM)
Previously, GQAMs used the RF frequency values in non-volatile memory (NVM)
when the GQAMs were rebooted. This could cause the GQAMs to momentarily
activate a newly muted RF frequency when the GQAMs were rebooted. CR 60963
prevents the GQAMs from using the NVM values for muted RF frequencies unless
they are in boot mode 0 (zero). When the GQAMs are in boot modes 1 or 2, they now
wait for one of the following actions before activating a newly muted RF frequency:
DNCS provisioning
Front-panel selection is made
Craft port selection is issued
CR 68628: CA Overlay Descriptor Length Increased for M-Card Modules
The CA Overlay descriptor length was increased to accommodate the Multi-Stream
The CA Overlay descriptor length was increased to accommodate the Multi-Stream
CableCARD™ module (M-Card™) packet/program identifier (PID).