Cisco Cisco Prisma II EDR Receiver 安装指南

 

32 

OL-32414-01 

5  Disengage the optical cable from the Fiber Fish tool and attach to the appropriate 

connector on the desired module. 

 

Feed each fiber through the fiber tray located beneath the Prisma XD Chassis. The 
fiber tray slides in and out to facilitate routing. 

 

Important: Observe laser safety precautions. See Laser Safety information earlier in 
this guide. 

Note: This procedure assumes that the chassis is mounted in a rack and that fiber 
optic cable has been run to the chassis front panel. 

 

CAUTION: 
The OPM is sensitive to electrostatic discharge. Always use an ESD strap or 
similar individual grounding device when handling or coming into contact 
with these modules. 

 

 

CAUTION: 

Removing and installing the OPM can shorten its useful life. Do not remove 
and insert the OPM more often than absolutely necessary. 

1  Select the appropriate OPM for the transmitter from the list provided in the 

Cisco EDR System data sheet. 
Note: See www.cisco.com for data sheets. 

2  Remove the dust plugs from the OPM and save them for possible future use. 
3 

Line up the OPM with the connector on the side of the transmitter as shown 
below, and slide the OPM into the connector until it clicks into place.