Cisco Cisco Prisma II EDR Receiver 安装指南
78-713378-01 Rev C
Operation Using LCI
4-9
Connecting Your Laptop Computer to the Chassis
Introduction
Before you start LCI, you must first connect your laptop computer to the chassis that
contains the module(s) you want to check.
Important: LCI communicates only with those modules located in the chassis your
Important: LCI communicates only with those modules located in the chassis your
computer is attached to. To check other modules, you must connect your computer
to the chassis they are located in.
Connecting to the Chassis
To connect your laptop to the chassis, follow these steps.
1.
Plug one end of a nine-pin serial extension cable into your computer.
2.
Plug the other end of the cable into the LCI port. This port is labeled “Local
Craft Interface”.