Cisco Cisco OptoStar II 1550nm Transmitter 安装指南
Operating using NMS Software, Continued
The table below lists the basic parameters of the OptoStar II forward driver
amplifier module.
amplifier module.
Basic Parameter
Description
Module Basic Information
Module Node Location
Module Node Location
Shows the IP of the node where the module is
located
S/N
Shows module serial number
Slot ID
Shows the ID of the slot where the module is
placed
Module Firmware Version
Shows firmware version
Module Temperature
Shows the current module temperature (°C)
Setup Parameters
The table below lists the setup parameters of the OptoStar II forward driver
amplifier module.
amplifier module.
Setup Parameters
Description
Factory Default
RF Input Information
Output Signal Slope
Output Signal Slope
Settings
Output signal slope settings
(range: 0~9 dB)
0 dB
Output Signal Gain
Settings
Output signal gain settings
(range: -9~0 dB)
0 dB
Comment
Comment
You may add applicable
comments as required.
None
3-28
Operation
OL-29667-02