Cisco Cisco OptoStar II Driver Amplifier 安装指南

下载
页码 67
Operating using Console Software 
This section introduces the procedures to use the OptoStar II console to manage 
the OptoStar II forward driver amplifier module. 
Before You Begin 
• 
One PC 
• 
Mini-USB data cable 
• 
OptoStar II console software installation package 
System Requirements 
• 
Supported operation system: Windows 7, Windows Vista, Windows Server 
2003, and Windows XP 
• 
Processor: 400 MHz Pentium or equivalent processor (minimum requirement); 
1 GHz Pentium or equivalent processor (recommended) 
• 
Memory: 96 MB (minimum requirement); 256 MB (recommended) 
• 
Hard drive: 500 MB free space required 
• 
Monitor: 800 x 600, 256-color (minimum requirement); 1024 x 768 high color, 
32-bit (recommended) 
Start 
1.  Make sure that the RF cables of the OptoStar II forward driver amplifier 
module are connected.
 
2.  Turn the front panel switch of the OptoStar II power supply module to ON 
position. The power supply module and the forward driver amplifier module 
will initialize for about 5 seconds, and the ICIM will load for about 25 
seconds.
 
Note: The system will achieve optimal working condition after one hour’s 
warm-up. 
 
Continued on next page 
 
 
 
3-16 
 
Operation 
OL-29667-02