Cisco Cisco OptoStar II 1310nm Transmitter 安装指南
Operating using ICIM LCD
This section describes how to use the OptoStar II ICIM LCD to operate the
OptoStar II intelligent communications interface module.
OptoStar II intelligent communications interface module.
Start
1. Make sure that the fiber and RF cables of other modules in the OptoStar II
Platform are connected.
2. Turn the front panel switch of the OptoStar II power supply module to ON
position. The power supply module and other modules will initialize for
about 5 seconds, and the ICIM will load for about 25 seconds.
about 5 seconds, and the ICIM will load for about 25 seconds.
Note: The system will achieve optimal working condition after one hour’s
warm-up.
warm-up.
The LCD now displays ICIM loading screen as shown below.
3. When the device initialization is complete, remove the ICIM display and
begin operation.
Continued on next page
OL-29660-03
Operation
3-3