Cisco Cisco OptoStar II Driver Amplifier 安装指南
Operating using NMS Software, Continued
3. When the device initialization is complete, connect to the Ethernet with the
RJ-45 connector on the rear panel of the ICIM. Connect the PC to the Ethernet.
The illustration below shows the connection method.
The illustration below shows the connection method.
4. Install and start the OptoStar II NMS software. See Cisco OptoStar II NMS
Installation and Operation Guide, P/N OL-29665 for detailed installation
procedures.
procedures.
Continued on next page
3-22
Operation
OL-29669-02