Cisco Cisco OptoStar II Driver Amplifier 安装指南

下载
页码 71
Operating using ICIM LCD, Continued 
Sub-menu 6 -- Optical Input Alarm Threshold 
The illustration below shows sub-menu 6 of the OptoStar II reverse receiver 
module - Optical Input Alarm Threshold. 
 
The optical input alarm threshold low limit is -17.0 dBm; and high limit is +3.0 
dBm. The cursor stays in the “Low” field by default. 
• 
To configure the low limit of optical alarm threshold (minimum output power 
is no less than -17.0 dBm):   
1.  Press SET button to start the configuration; 
2.  Press ▲▼ buttons to change the value, and press SET button to confirm; 
3.  Press ► button to move the cursor to “Set”; 
4.  Press SET button to save the configuration. 
• 
To configure the high limit of optical alarm threshold (maximum output power 
is no more than +3.0 dBm):   
1.  Press ▼ button to leave the cursor in the “High” field; 
2.  Press SET button to start the configuration; 
3.  Press ▲▼ buttons to change the value, and press SET button to confirm; 
4.  Press ► button to move the cursor to “Set’; 
5.  Press SET button to save the configuration. 
 
 
Continued on next page 
 
 
OL-29663-03 
Operation 
3-13