Cisco Cisco OptoStar II Driver Amplifier 安装指南

下载
页码 71
Operating using NMS Software
 
This section introduces the procedures to use the OptoStar II network 
management system (OptoStar II NMS) to manage the OptoStar II reverse 
receiver module. 
Before You Begin 
• 
One PC 
• 
A network cable 
• 
OptoStar II NMS software installation package 
System Requirements 
• 
Supported operation system: Windows 7, Windows Server 2008, Windows 
Vista, and Windows Server 2003 
• 
Processor: 400 MHz Pentium or equivalent processor (minimum requirement); 
1 GHz Pentium or equivalent processor (recommended) 
• 
Memory: 512 MB (minimum requirement); 1 GB (recommended) 
• 
Hard drive: 500 MB free space required 
• 
Monitor: 800 x 600, 256-color (minimum requirement); 1024 x 768 high color, 
32-bit (recommended) 
Start 
1.  Make sure that the fiber and RF cables of the OptoStar II reverse receiver 
module are connected. 
2.  Turn the front panel switch of the OptoStar II power supply module to ON 
position. The power supply module and the reverse receiver module will start 
initialization for about 5 seconds, and the ICIM will load for about 25 seconds. 
Note: The system will achieve optimal working condition after one hour’s 
warm-up. 
3.  When the device initialization is complete, connect to the Ethernet with the 
RJ-45 connector on the rear panel of the ICIM. Connect the PC to the Ethernet. 
The illustration below shows the connection method. 
 
 
 
Continued on next page 
OL-29663-03 
Operation 
3-23