Cisco Cisco OptoStar II 1550nm EDFA 安装指南
Operating using ICIM LCD, Continued
Sub-menu 5 -- Test Point
The illustration below shows sub-menu 5 of the OptoStar II reverse receiver
module - Test Point.
module - Test Point.
The factory default is: No Test Point. The cursor stays on “Set” by default.
•
To change the default test point:
1. Press ▲▼ buttons to select the test point, and the cursor always stays on
“Set”;
2. Press SET button to save the configuration.
Continued on next page
3-12
Operation
OL-29663-03