Cisco Cisco Prisma II EDR Receiver 安装指南
Chapter 4 Operation using LCI
62
78-4023013-01 Rev C
LCI Introduction
Laser Warning
WARNING:
Avoid personal injury! Use of controls, adjustments, or procedures other
than those specified herein may result in hazardous radiation exposure.
Avoid personal injury! The laser light source on this equipment (if a
transmitter) or the fiber cables connected to this equipment emit invisible
laser radiation. Avoid direct exposure to the laser light source.
Avoid personal injury! Viewing the laser output (if a transmitter) or fiber
cable with optical instruments (such as eye loupes, magnifiers, or
microscopes) may pose an eye hazard.
Do not apply power to this equipment if the fiber is unmated or unterminated.
Do not stare into an unmated fiber or at any mirror-like surface that could reflect
light emitted from an unterminated fiber.
Do not view an activated fiber with optical instruments (e.g., eye loupes,
magnifiers, microscopes).
Use safety-approved optical fiber cable to maintain compliance with applicable
laser safety requirements.
Even if the unit is off, there may still be hazardous optical levels present.
LCI Function
LCI is software that functions as a user interface for the Prisma II platform. LCI is
installed on a computer, which is then connected to a Prisma II Chassis. Using LCI,
you can configure and monitor the modules in the chassis to which the computer is
connected.
Important: Do not operate any Prisma II Chassis without a fan tray installed. If a fan
Important: Do not operate any Prisma II Chassis without a fan tray installed. If a fan
tray is not installed in the Prisma II Chassis, the LCI will not communicate with any
of the power supplies in that chassis.