Cisco SA III High Gain Dual-RC with 40 52 MHz Split 安装指南

 

This document explains how to replace an automatic gain control (AGC) module in a 
GainMaker

®

 System Amplifier and GainMaker Line Extender amplifier.  This 

replacement procedure should be performed on amplifiers that require an AGC 
module other than the one that was factory-installed. 

These instructions are intended for service personnel who are responsible for 
installing and maintaining GainMaker products.  The personnel should have 
experience with hardware component installation. 

This is the third release of this document. 

Refer to the following publications for more information about GainMaker 
amplifiers. 



 

GainMaker Broadband Amplifier Platform System Amplifier Modules and Housings 
Installation and Operation Guide, part number 593161 



 

GainMaker Broadband Amplifier Platform Line Extender Modules and Housings 
Installation and Operation Guide, part number 593057