Cisco Cisco Digital Service Access Node (DSAN) 8211 技术参考
4038958 Rev B
3
DSAN Coaxial Cable Pin Connector Installation
DSAN Coaxial Cable Pin Connector Installation
This section provides guidance for cutting coaxial cable pin connectors for the Cisco
DSAN. It provides a description of the housing port interfaces, the connector cut
length specifications, and suggestions to allow for easier pin connector insertion.
DSAN. It provides a description of the housing port interfaces, the connector cut
length specifications, and suggestions to allow for easier pin connector insertion.
Description
The Cisco DSAN housing has three KS ports that accept coaxial cable pin connectors.
These ports have an internal spring-loaded contact that enables pin connectors to be
inserted and replaced without requiring internal access to the product. Pin
connectors are installed by pushing the pin of the connector into the port, through
the internal spring-loaded contact, and then tightening the connector threads to the
housing.
These ports have an internal spring-loaded contact that enables pin connectors to be
inserted and replaced without requiring internal access to the product. Pin
connectors are installed by pushing the pin of the connector into the port, through
the internal spring-loaded contact, and then tightening the connector threads to the
housing.
The length of the cut pin connector has a specification of 1.5 to 1.6 inches. This
specification shall not be exceeded in order to maintain proper product performance.
There is a cut guide provided on the DSAN housing to aid in the cutting process of
the pin connector.
specification shall not be exceeded in order to maintain proper product performance.
There is a cut guide provided on the DSAN housing to aid in the cutting process of
the pin connector.
As shown in the following illustration, the edge of the guide is the minimum limit of
the pin connector length specification and the tip of the CUT arrow label is the
maximum limit of the length specification. The length specification measurement
locations are from the tip of the pin to the edge of the pin connector that will sit flush
with the housing when the pin connector is full installed.
the pin connector length specification and the tip of the CUT arrow label is the
maximum limit of the length specification. The length specification measurement
locations are from the tip of the pin to the edge of the pin connector that will sit flush
with the housing when the pin connector is full installed.