Cisco Cisco Web Security Appliance S370 發佈版本通知
3
Cisco IronPort Hard Drive Firmware Upgrade for C160, S160, and M160 Appliances
Hard Drive Firmware Upgrade Installation Instructions
The hard drive firmware upgrade package is provisioned only for appliances that require the
upgrade. If you do not see the Hard Drive Firmware Upgrade package in the list of availabe
upgrades, you can assume that your appliance does not require the upgrade and you can skip any
further upgrade steps.
upgrade. If you do not see the Hard Drive Firmware Upgrade package in the list of availabe
upgrades, you can assume that your appliance does not require the upgrade and you can skip any
further upgrade steps.
Step 4
Select the package Hard Drive Firmware upgrade.
Step 5
You will be prompted to reboot your machine. Click Yes.
Step 6
Wait approximately fifteen minutes.
Step 7
Your machine should automatically reboot after approximately fifteen minutes. The machine will then
automatically reboot a second time.
automatically reboot a second time.
Warning
If your machine does not automatically reboot in fifteen minutes, contact customer support. Do not
attempt to reboot your machine again.
attempt to reboot your machine again.
Note
After you run the firmware upgrade, the firmware upgrade package will display in the list of available
upgrades even after a successful installation. The presence of this package does not indicate a failed
upgrade.
upgrades even after a successful installation. The presence of this package does not indicate a failed
upgrade.
Step 8
To verify that the upgrade has run successfully, you can run the upgrade script again after the machine
has rebooted. If the upgrade was successful, the upgrade script will indicate that no disks require
upgrading.
has rebooted. If the upgrade was successful, the upgrade script will indicate that no disks require
upgrading.
Accessing the CLI
To run this upgrade, you must access the CLI. The instructions below provide information on accessing
the CLI.
the CLI.
Access to the CLI varies depending on the management connection method chosen while setting up the
appliance. Initially, only the admin user account has access to the CLI. You can add other users with
differing levels of permission after you have accessed the command line interface for the first time via
the admin account. The system setup wizard asks you to change the password for the admin account. The
password for the admin account can also be reset directly at any time using the password command. To
connect via Ethernet: Start an SSH or Telnet session with the factory default IP address 192.168.42.42.
SSH is configured to use port 22. Telnet is configured to use port 23.
appliance. Initially, only the admin user account has access to the CLI. You can add other users with
differing levels of permission after you have accessed the command line interface for the first time via
the admin account. The system setup wizard asks you to change the password for the admin account. The
password for the admin account can also be reset directly at any time using the password command. To
connect via Ethernet: Start an SSH or Telnet session with the factory default IP address 192.168.42.42.
SSH is configured to use port 22. Telnet is configured to use port 23.
To connect via a Serial connection: Start a terminal session with the communication port on your
personal computer that the serial cable is connected to. See the “Setup and Installation” chapter in the
Cisco IronPort AsyncOS Configuration Guide for more information. Enter the user name and password
below.
personal computer that the serial cable is connected to. See the “Setup and Installation” chapter in the
Cisco IronPort AsyncOS Configuration Guide for more information. Enter the user name and password
below.
Factory Default User name and Password
• Username:
admin
• Password:
ironport