Cisco Cisco SG500-52PP 52-port Gigabit Max PoE+ Stackable Managed Switch 技术参考
IPv6 Router Commands
816
78-21491-01 Command Line Interface Reference Guide
46
To disable IPv6 processing on an interface that has not been configured with an
explicit IPv6 address, use the no form of this command.
explicit IPv6 address, use the no form of this command.
Syntax
ipv6 enable
no ipv6 enable
Parameters
N/A.
Default Configuration
IPv6 addressing is disabled.
Command Mode
Interface Configuration
User Guidelines
This command automatically configures an IPv6 link-local Unicast address on the
interface while also enabling the interface for IPv6 processing. The no ipv6 enable
command does not disable IPv6 processing on an interface that is configured with
an explicit IPv6 address.
interface while also enabling the interface for IPv6 processing. The no ipv6 enable
command does not disable IPv6 processing on an interface that is configured with
an explicit IPv6 address.
Example
The following example enables VLAN 1 for the IPv6 addressing mode.
interface vlan 1
ipv6 enable
exit
46.10 ipv6 hop-limit
Use the ipv6 hop-limit command in Global Configuration mode to configure the
maximum number of hops used in all IPv6 packets that are originated by the router.
maximum number of hops used in all IPv6 packets that are originated by the router.
To return the hop limit to its default value, use the no form of this command.