Samsung WT10J7P 用户手册

 (In case drain pump)

   

1. Place a rag under the washer filter

  not to wet the floor.

 Space at last 15cm between the washer

2. Rotate the filter counterclockwise

 and the wall.

 and pull out the filter.

        

3. Remove dirts and rotate

  the filter clockwise until it

 

  If the washer is placed on an uneven or weak      locks in position.

 

  surface, noise or vibration may be occured. 

  Remark : Should be cleaned

 

  (Allowable is 2°) 

 

 

  Do not place the washer in steamy rooms or 

  Insert the drain hose(a) and push it tighly to be

 

  where the washer is directly exposed to rain. 

  connected as arrow direction.

 

  Moisture may destroy the electrical insulation

 

  and cause an electrical shock hazard. 

    

 

                             

 

   

   

  

 

 

             

 

  As plastic and electrical components are    

    

 

 

            

 

  affected by direct heat, never place the    

 

  washer near heaters, boilers,etc. 

 

 

  Do not place under direct sunlight. 

  Install the drain hose(A) about 70~80cm above the  

 

 

Before attempting to change the position of the

 

drain hose, disconnect the plug from the outlet.

 

1. Route the drain hose inside the machine. 

  2. Take out the drain hose from the opposite hole and 

     insert the drain hose into the hose holder. 

If the dregs are filled up in the lint filter after

Pull the upper side of the overflow filter

finishing the wash, push down(1) and pull it

with two fingers into the hole ‘A’

out(2) as shown in figure.

in the direction of arrow as

Remove the collected lint and rinse the filter net.

shown in the figure.

 

   

 

   

1. Rotate the cover window spin clockwise and pull out.

 

   

2. Cleaning the cover window spin.

 

   

3. Insert the cover window spin back and rotate it

 

   

  counterclockwise until locks in positon.

 

   

  Remark : Should be cleaned the cover window spin

                  at least 1 time a month.

Wipe off strains on the cabinet and operation 

panel with soft cloth. Do not use benzene, thinners, 

cleanser, or wax, nor scrub the washer with a brush.

Painted surfaces or plastic parts will be damaged.

3

DC68-01942E-01_WT10J_IB_ENG+ARAB4   4

8/9/2006   4:14:12 PM