Samsung External Dispenser Side-by-Side 用户手册

English - 10

A few things to mention first.
•  Make sure that you lift the door straight up so 

the hinges are not bent or broken.

•  Be careful not to pinch the water tubing and 

wire harness on the door.

•  Place doors on a protected surface to prevent 

scratching or damage.

1.  Remove a screw on the upper hinge cover 

( 

1 ). With the door open, disengage the two 

locking tabs with a flat-head screw driver ( 

2 ) 

and remove it while the lifting up the rear of the 
cover ( 

3 ), and then disconnect the wires by 

gently pulling them apart ( 

4 ).

4

3

2

1

2.  Removing the FIXER HINGE ,and next take off 

the upper hinge. 
Be careful that the door does not fall on you as 
you are removing it.

Be sure to keep track of all parts you are 
removing.

3.  Next, remove the door from the lower hinge 

( 

5 ) by carefully lifting the door straight up ( 6 ).

6

5

Be careful not to pinch the water tubing 
and wire harness on the door.

To reattach the freezer doors, replace parts in 
reverse order.

1.  The Water Line must be fully Inserted to the 

center of transparent coupler to prevent water 
leakage from the dispenser.

2.  Insert the 2 clips in the install pack and check 

that each clip holds the line firmly.

Center of transparent coupler

Clip A (¼”) (6.35 mm)

Do not cut the water line. 
Gently separate it from the coupler.

DA68-02500B-13.indb   10

13. 12. 4.   �� 7:12