Samsung WB30H7200GA/TL 用户手册
English - 11
INS
TALLA
TALLA
TION
Step-by-step installation
Step 1 - Select a location
Location requirements:
• On a solid, even surface without carpeting or flooring.
• Allowing at least 10 cm (4 inches) of distance between the washing machine and the wall.
• Not exposed to direct sunlight or rain as moisture may damage the electrical insulation, causing
• On a solid, even surface without carpeting or flooring.
• Allowing at least 10 cm (4 inches) of distance between the washing machine and the wall.
• Not exposed to direct sunlight or rain as moisture may damage the electrical insulation, causing
an electrical shock hazard.
• Require adequate ventilation.
• Not exposed to temperatures below 32 °F or 0 °C.
• Away from a heat source.
• enough space so that the washing machine doesn’t stand on its power cord.
• Not exposed to temperatures below 32 °F or 0 °C.
• Away from a heat source.
• enough space so that the washing machine doesn’t stand on its power cord.
Step 2 - Connect the water supply hose
1. Connect the L-shaped arm fitting for the cold water supply
hose to the cold water supply intake at the upper rear side
of the washing machine. Then tighten it by turning part (A)
clockwise by hand.
(*): applicable models only
of the washing machine. Then tighten it by turning part (A)
clockwise by hand.
(*): applicable models only
A
2. Remove the adaptor (B) from the other end of the water
supply hose (C).
B
C
3. Loosen the four screws on the adaptor using a Philips
screwdriver.
4. Connect the adaptor to the water tap by tightening all the
screws firmly while lifting the adaptor upwards.
Untitled-1 11
2014-11-26 4:21:16