Chaney Instrument model 00735 wireless thermometer and remote sensor 用户手册

settings.  Press the set button to confirm each setting.  The
settings will be in the following sequence:

 

12/24 hour mode

 

 Hour and minute settings

 

 Hour offset allows the time to be set ahead (to maintain
correct time, keep at 0)

 

Year, day and month

 Press 

the 

clear button for 3 seconds.  Press + or - to enter the

desired hour.  Press clear again and use the + or - to enter the
desired minutes.  Press clear again to confirm the time for the
alarm.

 

A bell icon will appear in the time panel to show that the alarm
is set.  To view the time the alarm is set for, press the clear
button.  The alarm time will display for 5 seconds and then
switch back to normal clock mode.

 

When alarm goes off, the alarm will sound for 1 minute.  Each
time you press the snooze button the alarm will “snooze” for
ten minutes, and then sound again.

To turn the alarm and snooze alarm off, press the + button.

 

At times, the main unit may display “---“ in the remote
temperature if outside interference is occurring.  Most of the
time the unit will re-sync the signal on it’s own.  However, if this
should continue to occur, the following may also be the reason:
A.  Low battery indicator(s).

B.  The sensor has been placed outside of the effective

transmission range (more than 100 feet).   Move the
sensor closer to the main unit.

C.  Sensor units may have outside interference that is

preventing proper transmission. Sources of interference
include but are not limited to metal surfaces, electrical
devices, etc. The sensor may need to be relocated if
interference continues.

LIMITED WARRANTY:  Should this product from the
Chaney Instrument Co. prove to be defective in material or
workmanship within one year of original purchase it will be
repaired or replaced.  his warranty does not cover damage
in shipment or failure caused by tampering, carelessness,
or abuse

.