Alcatel-Lucent omniacces-voip gateway 用户手册
VoIP Commands
Page 5-125
Command Usage
Specify Foreign Exchange Office Loop Start (FXO LS) debounce for battery reversal detector.
Syntax Options
Remarks
The
voice signaling protocol
command must be set to the corresponding protocol type before
any commands for E&M (Wink Start, Immediate Start, and Delay Start Signaling), and FXS/
FXO (Loop and Ground Start) commands will take effect.
FXO (Loop and Ground Start) commands will take effect.
voice signaling fxo ls battery reversal debounce
voice signaling channel <
slot/port/startChannel-endChannel
> fxo ls battery reversal debounce
<
value
>
Definitions:
slot
slot
Specifies chassis slot number where VSM is installed, (e.g.,
2
).
port
Specifies physical port number on voice daughtercard, (e.g.,
1
).
startChannel
The first number in the range of voice channels (e.g.,
1
).
endChannel
The last number in the range of voice channels (e.g.,
30
).
♦ Syntax Note ♦
Be sure to separate the start and end range numbers with a
hyphen (e.g.,
1-30
).
value
Specifies the time to use as a debouncer (delay interval) for debouncing the battery rever-
sal detector, in milliseconds from 0 to 60,000, (e.g.,
sal detector, in milliseconds from 0 to 60,000, (e.g.,
20
).
♦ Syntax Note ♦
Do not use commas when entering the fxo ls debounce value
for the battery reversal detector (for example,
for the battery reversal detector (for example,
10,000
will return
a syntax error message).
Default:
The default value is
The default value is
20
milliseconds.
Command Examples:
voice signaling channel 2/1/1-12 fxo ls battery reversal debounce 20
voice signaling channel 2/2/13-24 fxo ls battery reversal debounce 30000
voice signaling channel 2/3/1-30 fxo ls battery reversal debounce 60000
voice signaling channel 2/2/13-24 fxo ls battery reversal debounce 30000
voice signaling channel 2/3/1-30 fxo ls battery reversal debounce 60000