Alcatel-Lucent omniacces-voip gateway 用户手册
VoIP Commands
Page 5-145
Command Usage
Specify Foreign Exchange Office (FXO) Ground Start (GS) debounce interval for loop current
detector.
detector.
Syntax Options
Remarks
The
voice signaling protocol
command must be set to the corresponding protocol type before
any commands for E&M (Wink Start, Immediate Start, and Delay Start Signaling), and FXS/
FXO (Loop and Ground Start) commands will take effect.
FXO (Loop and Ground Start) commands will take effect.
voice signaling fxo gs loop current debounce
voice signaling channel <
slot/port/startChannel-endChannel
> fxo gs loop current debounce
<
value
>
Definitions:
slot
slot
Specifies chassis slot number where VSM is installed, (e.g.,
2
).
port
Specifies physical port number on voice daughtercard, (e.g.,
1
).
startChannel
The first number in the range of voice channels (e.g.,
1
).
endChannel
The last number in the range of voice channels (e.g.,
30
).
♦ Syntax Note ♦
Be sure to separate the start and end range numbers with a
hyphen (e.g.,
1-30
).
value
Specifies the debounce (delay interval) for debouncing the loop current detector, in milli-
seconds from 1 to 1,000, (e.g.,
seconds from 1 to 1,000, (e.g.,
20
).
♦ Syntax Note ♦
Do not use commas when entering the fxs gs debounce interval
value for loop current detection (for example,
value for loop current detection (for example,
1,000
will return
a syntax error message).
Default:
The default value is
The default value is
20
milliseconds.
Command Examples:
voice signaling channel 2/1/1-12 fxo gs loop current debounce 20
voice signaling channel 2/2/13-24 fxo gs loop current debounce 500
voice signaling channel 2/3/1-30 fxo gs loop current debounce 1000
voice signaling channel 2/2/13-24 fxo gs loop current debounce 500
voice signaling channel 2/3/1-30 fxo gs loop current debounce 1000