ASUS mm17t 产品宣传页
MM17 Quick Start Guide
Safety
Instructions
Observe the following safety guidelines when connecting and using your monitor:
•
Be sure that your monitor is electrically rated to operate with the AC power available in your location.
•
Locate your monitor near an easily accessible electrical outlet.
•
Place the monitor on a solid surface and treat it carefully. The screen can be damaged if dropped, sharply
hit, or touched with a sharp or abrasive implement.
hit, or touched with a sharp or abrasive implement.
•
Put your monitor in a location with low humidity and a minimum of dust.
•
Never use your monitor if the power cord has been damaged. Do not allow anything to rest on the power
cord, and keep the cable away from where people could trip over it.
cord, and keep the cable away from where people could trip over it.
•
Never insert anything metallic into the monitor openings. Doing so may create the danger of electric shock.
•
To avoid electric shock, never touch the inside of the monitor. Only a qualified technician should open the
monitor’s case.
monitor’s case.
•
Be sure to hold the plug, not the cable, when disconnecting the monitor from an electrical outlet.
•
Openings in the monitor cabinet are provided for ventilation. To prevent overheating, these openings
should not be blocked or covered. Also, avoid using the monitor on a bed, sofa, rug, or other soft surface.
Doing so may block the ventilation openings in the bottom of the cabinet. If you put the monitor in a
bookcase or some other enclosed space, be sure to provide adequate ventilation.
should not be blocked or covered. Also, avoid using the monitor on a bed, sofa, rug, or other soft surface.
Doing so may block the ventilation openings in the bottom of the cabinet. If you put the monitor in a
bookcase or some other enclosed space, be sure to provide adequate ventilation.
•
Do not expose the monitor to rain or use it near water. If the monitor accidentally gets wet, unplug it and
contact an authorized dealer immediately. You can clean the exterior of the monitor with a damp cloth
when necessary, but be sure to unplug the monitor first.
contact an authorized dealer immediately. You can clean the exterior of the monitor with a damp cloth
when necessary, but be sure to unplug the monitor first.
•
If your monitor does not operate normally—in particular, if there are any unusual sounds or smells coming
from it—unplug the monitor immediately and contact an authorized dealer or service center.
from it—unplug the monitor immediately and contact an authorized dealer or service center.
Connecting Your Monitor to a Computer
1.
AC Input Socket
2.
Audio Jack (MM17T only)
3.
DVI-D Port (MM17T only)
4.
VGA (D-SUB) Port
5.
Earphone Jack (MM17T only)
6.
Cable Binder
Turn off your computer before performing the procedure below.
1.
1.
Connecting the Signal Cable: Plug one end of the 15-pin VGA cable to the monitor’s VGA port, the other
end to the computer's VGA socket and tighten the two screws on the cable connector. Moreover, for
MM17T, you can buy an extra 24-Pin DVI-D cable from your dealer for the digital signal connection if
preferred.
end to the computer's VGA socket and tighten the two screws on the cable connector. Moreover, for
MM17T, you can buy an extra 24-Pin DVI-D cable from your dealer for the digital signal connection if
preferred.
2.
Connecting the Power Cord: Plug on end of the AC-power cord one end to the monitor’s AC input socket,
the other end to the power outlet.
the other end to the power outlet.
3.
Connecting the Audio Cable (MM17T only): Plug the audio cable between the computer multi-media (or
audio) card's audio output and monitor's audio jack.
audio) card's audio output and monitor's audio jack.
4.
Turn on your monitor and computer.
Notes: If your monitor displays an image, installation is complete. If it does not display an image, refer to the
troubleshooting section of this guide.
Monitor Quick Start Guide