ASUS wl-300 用户手册
Chapter 5
SpaceLink Access Point
43
Chapter 5 -Troubleshooting
Problem
The SpaceLink Access Point Manager still cannot find or connect
to the SpaceLink Access Point after verifying the IP address and
LAN cable, changes cannot be made, or password is lost.
to the SpaceLink Access Point after verifying the IP address and
LAN cable, changes cannot be made, or password is lost.
Solution
In case the SpaceLink Access Point is inaccessible, you can
restore the SpaceLink Access Point’s factory default settings.
Use a straightened paper clip to press the button located in
the hole labeled “Reset” on the back of the SpaceLink Access
Point and keep it depressed over 5 seconds. The amber power
LED will darken and then light up when reset is successful.
restore the SpaceLink Access Point’s factory default settings.
Use a straightened paper clip to press the button located in
the hole labeled “Reset” on the back of the SpaceLink Access
Point and keep it depressed over 5 seconds. The amber power
LED will darken and then light up when reset is successful.
Reset to Defaults
The following are factory default values. These values will be present when you
first receive your SpaceLink Access Point, if you push the reset button on the
back of the SpaceLink Access Point over 5 seconds, or if you click the “Reset to
Defaults” on the “General” page of the SpaceLink Access Point Manager.
first receive your SpaceLink Access Point, if you push the reset button on the
back of the SpaceLink Access Point over 5 seconds, or if you click the “Reset to
Defaults” on the “General” page of the SpaceLink Access Point Manager.
Name
Default Value
Password
“asus”
IP address assignment
obtain an IP address automatically
Primary port
Ethernet
IP address
192.168.39.130
Subnet mask
255.255.255.0
Gateway
0.0.0.0
SSID
“default”
Channel
1
WEP type
WEP disable
AP name
“ASUS AP”
Operational mode
AP mode
Only allow IP packets
Disable
Authorization table
Disable
Host AP / Wireless Bridge MAC Add.
00-00-00-00-00-00
Fragmentation threshold
2346
RTS threshold
2346
Preamble mode
Long preamble
Authentication type
Both