att tl32200 用户手册

7

Getting started

Battery installation and charging

Once you have installed the battery, the screen indicates the 
battery status (see the table below). If necessary, place the 
handset in the charger to charge the battery. 
For best performance, keep the handset in 
the charger when not in use. The battery is 
fully charged after 16 hours of continuous 
charging. See 

Technical specifications on 

page 33 for battery operating times.

If the screen is blank, you need to charge 
the handset without interruption for at least 30 minutes to give 
the handset enough charge to use the telephone for a short 
time. The screen shows 

Low battery until you have charged 

the battery without interruption for at least 30 minutes. The 
following table summarizes the battery charge indicators and 
actions to take.

The screen is blank or 
shows  
Place in charger.

Battery has no or 
very little charge. The 
handset cannot be used.

Charge without 
interruption until the 
screen shows  
Low battery or 
HANDSET X (at least  
30 minutes).

The screen shows  

Low battery and   
flashes.

Battery has enough 
charge to be used for a 
short time.

Charge without 
interruption until the 
screen shows  
HANDSET X (at least  
30 minutes).

The screen shows 
HANDSET X and the 
battery icon shows  

,   or  .

Battery is charged.

To keep the battery 
charged, place it in the 
charger when not in use.

Battery status icon

HANDSET 1

11/20

10:30

PM