Asrock alivenf6g-vsta 用户手册

3 1

2.17

2.17 Untied Overclocking T

Untied Overclocking T

Untied Overclocking Technology

echnology

This motherboard supports Untied Overclocking Technology, which means during
overclocking, FSB enjoys better margin due to fixed PCI / PCIE buses. Before you
enable Untied Overclocking function, please enter “Overclock Mode” option of BIOS
setup to set the selection from [Auto] to [CPU, PCIE, Async.]. Therefore, CPU FSB is
untied during overclocking, but PCI / PCIE buses are in the fixed mode so that FSB can
operate under a more stable overclocking environment.

Please refer to the warning on page 8 for the possible overclocking risk before
you apply Untied Overclocking Technology.

2.16.2 Installing Windows

Vista

/ Vista

64-bit With

RAID Functions

If you want to install Windows

Vista

or Windows

Vista

64-bit on your SATA /

SATAII HDDs with RAID functions, please follow below steps.

STEP 1: Set Up BIOS.
A.

Enter BIOS SETUP UTILITY

Advanced screen

IDE Configuration.

Set the “SATA Operation Mode” option to [RAID].

STEP 2: Use “RAID Installation Guide” to set RAID configuration.
Before you start to configure RAID function, you need to check the RAID installation
guide in the Support CD for proper configuration. Please refer to the BIOS RAID
installation guide part of the document in the following path in the Support CD:
.. \ RAID Installation Guide

STEP 3: Install Windows

Vista

/ Windows

Vista

64-bit OS on your

system.
Insert the Windows

Vista

/ Windows

Vista

64-bit optical disk into the optical

drive to boot your system, and follow the instruction to install Windows

Vista

Windows

Vista

64-bit OS on your system. When you see “Where do you want to

install Windows?” page, please insert the ASRock Support CD into your optical drive,
and click the “Load Driver” button on the left on the bottom to load the NVIDIA

RAID

drivers. NVIDIA

RAID drivers are in the following path in our Support CD:

.. \ I386 \ Vista

(For Windows

Vista

OS)

.. \ AMD64 \ Vista64

(For Windows

Vista

64-bit OS)

After that, please insert Windows

Vista

/ Windows

Vista

64-bit optical disk into

the optical drive again to continue the installation.

NOTE. If you install Windows

Vista

/ Windows

Vista

64-bit on IDE HDDs and want to

manage (create, convert, delete, or rebuild) RAID functions on SATA / SATAII HDDs,
you still need to set up “SATA Operation Mode” to [RAID] in BIOS first. Then, please set
the RAID configuration by using the Windows RAID installation guide in the following
path in the Support CD:
.. \ RAID Installation Guide