Asrock 770 extreme3 用户手册

1 8

FLOPPY1

Pin1

the red-striped side to Pin1

2.6 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
•

Floppy Connector

(33-pin FLOPPY1)
(see p.10 No. 27)

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the

connector.

Primary IDE connector (Blue)

(39-pin IDE1, see p.10 No. 9)

Note: Please refer to the instruction of your IDE device vendor for the details.

Serial ATAII Connectors

These four Serial ATAII (SATAII)

(SATAII_1: see p.10, No. 14)

connectors support SATAII

(SATAII_2: see p.10, No. 18)

or SATA hard disk for internal

(SATAII_3: see p.10, No. 15)

storage devices. The current

(SATAII_4: see p.10, No. 16)

SATAII interface allows up to
3.0 Gb/s data transfer rate.

connect the black end
to the IDE devices

connect the blue end

to the motherboard

IDE1

PIN1

80-conductor ATA 66/100/133 cable

SATAII_1 SATAII_3

SATAII_2 SATAII_4

Serial ATA (SATA)

Either end of the SATA data cable

Data Cable

can be connected to the SATA /

(Optional)

SATAII / SATA3 hard disk or the
SATAII / SATA3 connector on this
motherboard.

Serial ATA3 Connectors

These two Serial ATA3

(SATA3_1: see p.10, No. 11)

(SATA3) connectors support

(SATA3_2: see p.10, No. 10)

SATA data cables for internal
storage devices. The current
SATA3 interface allows up to
6.0 Gb/s data transfer rate.

TA3_1

TA3_2