Asrock k10n750sli-110db 用户手册

2 6

2 6

2 6

2 6

2 6

FLOPPY1

Pin1

the red-striped side to Pin1

connect  the black end
to the IDE devices

connect the blue end

to the motherboard

IDE1

PIN1

80-conductor ATA 66/100/133 cable

2.7 Onboard Headers and Connectors

2.7 Onboard Headers and Connectors

2.7 Onboard Headers and Connectors

2.7 Onboard Headers and Connectors

2.7 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
•

Floppy Connector

(33-pin FLOPPY1)
(see p.12,  No. 25)

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the

connector.

Primary IDE connector (Blue)

(39-pin IDE1, see p.12,  No. 9)

Note: Please refer to the instruction of your IDE device vendor for the details.

Serial ATA II Connectors

These six Serial ATAII

(SATAII_1 (PORT0):

(SATAII) connectors support

see  p.12, No. 17)

SATA data cables for internal

(SATAII_2 (PORT1):

storage devices. The current

see  p.12, No. 14)

SATAII interface allows up to

(SATAII_3 (PORT2):

3.0 Gb/s data transfer rate.

see  p.12, No. 16)
(SATAII_4 (PORT3):
see  p.12, No. 15)
(SATAII_5 (PORT4):
see  p.12, No. 13)
(SATAII_6 (PORT5):
see  p.12, No. 12)

SATAII_6 (PORT5) connector can be used for internal storage device
or be connected to eSATAII connector to support eSATAII device.
Please read “eSATAII Interface Introduction” on page 33 for details
about eSATAII and eSATAII installation procedures.

SATAII_6 (PORT5)

SATAII_5 (PORT4)

SATAII_4 (PORT3)

SATAII_3 (PORT2)

SA

TAII_2 (POR

T1)

SA

TAII_1 (POR

T0)