Asrock k7vt4a+ 用户手册

1 5

2.6

Connectors

Connectors are NOT jumpers. DO NOT place jumper caps over these

connectors. Placing jumper caps over the connectors will cause perma-

nent damage of the motherboard!

Connector

Figure

Description

FDD Connector

(33-pin FLOPPY1)

(see p.7 item 13)

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the

connector.

Primary IDE Connector (Blue)

Secondary IDE Connector (Black)

(39-pin IDE1, see p.7 item 8)

(39-pin IDE2, see p.7 item 7)

80-conductor, ATA 66/100/133 cable

Note: If you use only one IDE device on this motherboard, please set the IDE

device as “Master”. Please refer to the instruction of your IDE device vendor

for the details. Besides, to optimize compatibility and performance, please

connect your hard disk drive to the primary IDE connector (IDE1, blue) and

CD-ROM to the secondary IDE connector (IDE2, black).

USB 2.0 Connector

ASRock I/O

provides you 4

(9-pin USB45)

default USB 2.0 ports on the rear

(see p.7 item 17)

panel. If the rear USB ports are

not sufficient, this USB 2.0

connector is available to support

2 additional USB 2.0 ports.

Infrared Module Connector

This connector supports an

(5-pin IR1)

optional wireless transmitting

(see p.7 item 18)

and receiving infrared module.

USB_PWR

P+5

P-5

P+4

P-4

GND

DUMMY

GND

+5V

IRTX

IRRX

IDE1

PIN1

IDE2

PIN1

FLOPPY1

Pin1

connect the black end

to the IDE devices

connect the blue end

to the motherboard

the red-striped side to Pin1