Asrock a770crossfire 用户手册

2 5

FLOPPY1

Pin1

the red-striped side to Pin1

2.8 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
•

Floppy Connector

(33-pin FLOPPY1)
(see p.11 No. 25)

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the

connector.

Primary IDE connector (Blue)

(39-pin IDE1, see p.11 No. 9)

Note: Please refer to the instruction of your IDE device vendor for the details.

Serial ATAII Connectors

These six Serial ATAII (SATAII)

(SATAII_1:

connectors support SATAII

see p.11, No. 18)

or SATA hard disk for internal

(SATAII_2:

storage devices. The current

see p.11, No. 19)

SATAII interface allows up to

(SATAII_3:

3.0 Gb/s data transfer rate.

see p.11, No. 17)
(SATAII_4:
see p.11, No. 15)
(SATAII_5:
see p.11, No. 16)
(SATAII_6:
see p.11, No. 14)

connect the black end
to the IDE devices

connect the blue end

to the motherboard

IDE1

PIN1

SATAII_6 connector can be used for internal storage device or be
connected to eSATAII connector to support eSATAII device. Please read
“eSATAII Interface Introduction” on page 32 for details about eSATAII
and eSATAII installation procedures.

80-conductor ATA 66/100/133 cable

SATAII_1 SATAII_3 SATAII_5

SATAII_2 SATAII_4 SATAII_6