Asrock k7s41gx 用户手册

1 6

For example, “Athlon XP 2000+” is an 1666MHz CPU:  12.5 (Multiplier) X 133MHz (External frequency) = 1666MHz

FID jumpers setting:

The jumper caps are not provided by ASRock. Please understand that ASRock

does not guarantee and support the adjustment of multiplier. These jumpers

setting may not apply to all multiplier-locked or even some unlocked AMD

CPU. Frequencies other than the recommended CPU bus frequencies may

cause the instability of the system or damage the CPU.

2.6 Connectors

Connectors are NOT jumpers. DO NOT place jumper caps over these

connectors. Placing jumper caps over the connectors will cause perma-

nent damage of the motherboard!

Connector

Figure

Description

FDD Connector

(33-pin FLOPPY1)

(see p.7/p.8  No. 17)

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the

connector.

Primary IDE Connector (Blue)

Secondary IDE Connector (Black)

(39-pin IDE1, see p.7/p.8  No. 8)

(39-pin IDE2, see p.7/p.8  No. 7)

80-conductor, ATA 66/100/133 cable

Note: If you use only one IDE device on this motherboard, please set the IDE

device as “Master”. Please refer to the instruction of your IDE device vendor

for the details. Besides, to optimize compatibility and performance, please

connect your hard disk drive to the primary IDE connector (IDE1, blue) and

CD-ROM to the secondary IDE connector (IDE2, black).

1
1
1
1
1

IDE1

PIN1

IDE2

PIN1

FLOPPY1

Pin1

connect  the black end

to the IDE devices

connect the blue end

to the motherboard

the red-striped side to Pin1