Asrock k7s8xe r3.0 用户手册

1 2

2.5 Installation of Memory Modules (DIMM)

K7S8X / K7S8XE motherboard provides three 184-pin DDR (Double Data Rate) DIMM

slots.

Please make sure to disconnect power supply before adding or

removing DIMMs or the system components.

Step 1.

Unlock a DIMM slot by pressing the retaining clips outward.

Step 2.

Align a DIMM on the slot such that the notch on the DIMM matches the break

on the slot.

Step 3.

Firmly insert the DIMM into the slot until the retaining clip snap back in place

and the DIMM is properly seated.

2.6 Expansion Slots (PCI and AGP Slots)

There are 5 PCI slots and 1 AGP slot on K7S8X / K7S8XE motherboard.

PCI slots: PCI slots are used to install expansion cards that have the 32-bit PCI

interface.

AGP slot: The AGP slot is used to install a graphics card.

The ASRock AGP  slot  has a special locking mechanism which can

securely fasten the graphics card inserted.

Please do NOT insert a 3.3V AGP card into the AGP slot of K7S8X or

K7S8XE motherboard! It may cause permanent damage!

Installing an expansion card

Step 1.

Before installing the expansion card, read the documentation of the

expansion card and make necessary hardware settings for the card.

Step 2.

Remove the system unit cover (if your motherboard is already installed in a

chassis).

Step 3.

Remove the bracket facing the slot that you intend to use. Keep the screws

for later use.

Step 4.

Align the card connector with the slot and press firmly until the card is

completely seated on the slot.

Step 5.

Fasten the card to the chassis with screws.

Step 6.

Replace the system cover.