Asrock k7s8x 用户手册

1 5

Clear CMOS

CLRCMOS2

(see p.7/p.8 item 15)

Note: CLRCMOS2 allows you to clear the data in CMOS. The data in CMOS includes

system setup information such as system password, date, time, and system

setup parameters. To clear and reset the system parameters to default setup,

please turn off the computer and unplug the power cord, then use a jumper

cap to short the pins on CLRCMOS2 for 3 seconds. Please remember to

remove the jumper cap after clearing the CMOS.

2.8 Connectors

Connectors are NOT jumpers.  DO NOT place jumper caps over

these connectors.

Connector

Figure

Description

FDD connector

(33-pin FLOPPY1)

(see p.7/p.8 item 14)

Note: Match the red marking on the floppy ribbon cable with Pin1.

Primary IDE connector (Blue)

Secondary IDE connector (Black)

(39-pin IDE1, see p.7/p.8 item 8)

(39-pin IDE2, see p.7/p.8 item 7)

Note: To optimize compatibility and performance, please connect your hard disk

drive to the primary IDE connector (IDE1, blue) and CD-ROM to the

secondary IDE connector (IDE2, black).

2-pin jumper

FLOPPY1

Pin1

Red marking

IDE1

PIN1

IDE2

PIN1

connect  the black end

to the IDE devices

connect the blue end

to the motherboard

80-Pin ATA 100/133 cable