Asrock p4i45pe+ 用户手册

1 4

2.8 Jumpers Setup

The illustration shows how jumpers are

setup. When the jumper cap is placed on

pins, the jumper is “Short”. If no jumper cap

is placed on pins, the jumper is “Open”. The

illustration shows a 3-pin jumper whose pin1

and pin2 are “Short” when jumper cap is

placed on these 2 pins.

J u m p e r

Setting

Description

FSB

“NORMAL” (short pin1, pin2)

(see p.8  item  1)

is the default setting for the

FSB jumper. “800” (short

pin2, pin3) is the setting for

the over clocking of CPU

frequency.

PS2_USB_PWR1

Short pin2, pin3 to enable

(see p.8  item  2)

+5VSB (standby) for PS/2

or USB wake up events.

Note: To select +5VSB, it requires 2 Amp and higher standby current provided by

power supply.

JR1

(see  p.8 item 26)

JL1

(see  p.8 item 25)

Note: If the jumpers JL1 and JR1 are short, both the front panel and the rear panel

audio connectors can work.

Clear CMOS

(CLRCMOS0, 2-pin jumper)

(see p.8  item  13)

Note: CLRCMOS0 allows you to clear the data in CMOS. The data in CMOS includes

system setup information such as system password, date, time, and system

setup parameters. To clear and reset the system parameters to default setup,

please turn off the computer and unplug the power cord, then use a jumper

cap to short the pins on CLRCMOS0 for 3 seconds. Please rem ember to

remove the jumper cap after clearing the CMOS. If you need to clear the CMOS

when you just finish updating the BIOS, you must boot up the system first, and

then shut it down before you do the clear-CMOS action.

2-pin jumper

JR1

JL1