Asrock p4i45pe+ 用户手册

2 1

TYPE

To set the type of the IDE device, first, please select “IDE Devices” on Main

menu and press <Enter> to get into the sub-menu. Then, select among

“Primary IDE Master”, “Primary IDE Slave”, “Secondary IDE Master”, and

“Secondary IDE Slave” to make configuration of its type. After making your

selections on this sub-menu, press <ESC> key to return to the upper menu,

in whcih the hard disk drive field will display the size of the hard disk drive

that you configured. Below are the configuration options.

[USER]

It allows user to manually enter the number of cylinders, heads, and

sectors per track for the drive.

Before attempting to configure a hard disk drive, make sure you

have the correct configuration information supplied by the drive

manufacturer. Incorrect settings may cause the system to fail to

recognize the installed hard disk.

[Auto]

Select [Auto] to automatically detect hard disk drive. If auto-detection

is successful, the BIOS Setup automatically fills in the correct values

for the remaining fields on this sub-menu. If the auto-detection fails, it

may due to that the hard disk is too old or too new. If the hard disk was

already formatted on an older system, the BIOS Setup may detect

incorrect parameters. In these cases, select [User] to manually enter

the IDE hard disk drive parameters.

After entering the hard disk information into BIOS, use a disk utility, such as

FDISK, to partition and format new IDE hard disk drives. This is necessary

so that you can write or read data from the hard disk. Make sure to set the

partition of the Primary IDE hard disk drives to active.

AMIBIOS SETUP UTILITY - VERSION 3.31a

Main

Type
Cylinders
Heads
Write Precompensation
Sectors
Maximum Capacity
LBA Mode
Block Mode
Fast Programmed I/O Modes
32 Bit Transfer Mode
Ultra DMA Mode

[

Setup Help

]

F1:Help

Esc:Previous Menu

F9:Setup Defaults
F10:Save & Exit

+/-:Change Values

Enter:Select

Sub-Menu

:Select Item

Primary IDE Master:

On
On
Auto
On
Auto

Select how to set the
parameters of drive,

Or
Select [AUTO] to set
all HDD parameters
automatically.

Auto