Alinco dj-v17t 用户手册

4.Basic Operation

In conventional repeater systems, a signal received on one frequency is retransmitted

on another frequency.  The difference between these two frequencies is called the

offset frequency.  The selectable offset frequency of this unit is from 0 to 99.995MHz.

1. Press the FUNC key, and while 

is displayed, press the 

key to display the

current offset frequency and shift direction settings.

2. Each time the 

key is pressed the shift direction changes as indicated below.

A (-) means that the TX frequency is lower than the RX frequency.

A (+) means vice versa.

3. Rotate the dial while the shift frequency is being displayed.

Clockwise: each click increases the frequency by one tuning step.

Counter-clockwise: each click decreases the frequency by one tuning step.

Press the FUNC key and rotate the dial to increase or decrease the frequency in 1MHz steps.

4. Press any key except for the MONI or FUNC key to complete setting.

This mode allows recalling and operating the preprogrammed frequency or setting in

the memory channels.  This unit provides up to 200 memory channels, 1 CALL

channel and 1 Repeater-Access function memory.

1. Select a frequency and operating parameters to be programmed in the VFO mode.

Programmable parameters are explained later.  Press the 

key.   "

" appears

on the display.

2. Press the FUNC key to display 

.

3. Rotate the main dial to select the desired memory channel number while 

is

displayed.  An empty channel is shown with a flashing "

".  Select C for CALL

channel programming.  "rP ALLFREQ" is explained later.

4. By pressing the 

key again while 

is on the display, a beep sounds and

programming is completed.

4.5

Please refer to "Selective Calling" (page 36) to set the CTCSS/DCS tones
usually required for conventional Repeater-Accesses.

-0.600

+0.600 

OST-OF